Pass4side Latest Exam SUN 310-880 Demo - 2

SUN 310-880 SUN Certified Senior System Support Engineer
Updated: 2008-10-10
More Infomation Visit: http://www.pass4side.com
6. A customer wants a new PCI Ethernet card installed in a Sun Fire E2900. After

physically installing the card,
you want to verify that the system recognizes the card before the OS is booted. Which

two OBP commands can
you use to accomplish this? (Choose two.)
A. devalias
B. show-devs
C. show-nets
D. .inet-addr
E. probe-net-all
F. probe-scsi-all
Answer: BC

7. You are installing a Sun Fire E2900 on a customer site and the customer wants to

configure the POST level on
the System Controller to run at the maximum level. What command from the LOM prompt

should you run to
configure the SC POST level?
Pass4Side SUN 310-880
Pass4Side Help you pass any IT Exams! Page 4 of 8
A. setupsc
B. setuplom
C. setupnetwork
D. setupplatform
Answer: A

8. You begin to boot a Sun Fire V1280 server, but realize some additional settings need

to be checked. You decide
to stop the boot and bring the system to the OK prompt. How can you accomplish this during the boot process?
A. Type ~..
B. Type break.
C. Go to the lom > prompt and type break.
D. Go to the lom > prompt and type reset -x.
Answer: C

9. A customer is connected to a remote machine and needs to know some information about the CPUs installed.
Which two Solaris commands can be used to determine the number of CPUs installed, and the speed of each?
(Choose two.)
A. psradm
B. cpustat
C. devfsadm
D. psrinfo -v
E. prtdiag -v
Answer: DE

10. You are checking a Sun Fire V880 system configuration for dual-loop fibre disk operation. What command will show the existence of dual-loop?
A. prtfru -v
B. prtconf -pv
C. prtdiag -v
D. luxadm display enclosure
E. luxadm -e disp_port_map path_to_disk
Answer: D