Pass4side SUN 310-880 Latest Exam 1

SUN 310-880 SUN Certified Senior System Support Engineer
Updated: 2008-10-10
More Infomation Visit: http://www.pass4side.com
1. You are installing a Sun Fire 15K server. The System Controller comes with a pre-installed, EIS compliant
Solaris image. You need to confirm that this image was installed with the current EIS CD.
Which file can be used to determine the current version of the EIS CD used on a system?
A. /etc/motd
B. /etc/release
C. /sun/install.log
D. $SMSETC/SMS/config/smsversion.cf
Answer: C

2. You are conducting a pre-install site survey for 8 Sun Fire V890s and 4 Sun Rack 900s in a raised floor
environment. The customer wants to install them in 2 rows, one in front of the other.
How should you configure the placement of the systems?
A. The Sun Fire V890s should be placed back to back, and perforated floor tiles should be placed in front of the
racks.
B. The Sun Fire V890s should be placed back to back, and perforated floor tiles should be placed at the rear of the
racks.
C. The Sun Fire V890s should be facing the same direction, one behind the other, and perforated floor tiles should
be placed in front of the racks.
D. The Sun Fire V890s should be facing the same direction, one behind the other, and perforated floor tiles should
be placed both in front of, and at the rear of the racks.
Answer: A

3. You are installing a 66 Mhz PCI card in a Sun Fire 6800. The customer tells you they want the best performance
from the card. (Note, the customer has no PCI+ I/O Boards installed in the system)
How many slots in an 8-slot PCI I/O Board can operate at 66 Mhz?
A. 0
B. 1
C. 2
D. 3
E. 4
Answer: C

4. You are installing a used StorEdge 3310 SCSI array on a Sun Fire V480 server. You want to determine if the
disks have updated firmware. Which command should you use to evaluate the firmware level?
A. fru stat
B. iostat -En
C. iostat -tcx
D. prtconf -pv
E. luxadm -e probe | grep version
F. luxadm display -v /dev/rdsk/cXtXdX
Answer: B

5. You have performed a setkeyswitch on for domain A on a Sun Fire 6800 where the auto-boot? OBP variable is
set to false. What command at the OBP should you run to find the status of the POST?
A. showlog-results
B. showlog results
C. show-log-results
D. showpost-results
E. showpost results
F. show-post-results
Answer: F